OPERATION OPERATION ADJUSTMENT 3 ADJUST OPERATOR'S SEAT When adjusting the position of the operator's seat, always set the work equipment lock lever to the LOCK position to prevent any accidental contact with the control levers. q Always adjust the operator's seat before starting each operation or when the operators change shift. q When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal can be fully depressed. (A) Fore-and-aft adjustment Pull lever (1), set the seat to a position where it is easy to oper- ate, then release the lever. Fore-aft adjustment:
160 mm (6.3 in) (8 stages) (B) Weight adjustment of seat Turn knob (2) under the seat to match the weight adjustment scale with your own weight. The weight can be adjusted to 50 to 120 kg (110 to 265 lb). REMARK If you want to make the seat softer, turn the weight adjustment to a lower weight; if you want to make the seat harder, adjust to a higher weight.When operating on uneven surfaces, adjust the seat to a harder setting. (C) Adjust reclining angle Pull up lever (3) and set the seat back to a position which is comfortable for operation, then release the lever. Sit with your back against the seat back when adjusting.
If your back is not touching the seat back, the seat back may suddenly move forward. REMARK The seat can be reclined more when the seat is pushed to the front. The amount of reclining decreases as the seat is pushed back, so when moving the seat back, return the seatback to the upright position. 3-82 WARNING