Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST 4 (Machines equipped with cab) If the belt is loose, it will slip and the cooling effect will be reduced. When the belt is new, there will be initial elongation, so always adjust again after 2 or 3 days. CHECKING 1. Open the engine side cover on the right side of the chassis. 2. Press a point midway between the drive pulley (1) and compressor pulley (2) with your finger (approx. 98 N (10 kgf)) and check that the tension is 15 to 18 mm (0.59 to 0.71 in). ADJUSTING 1. Open the engine side cover on the left side of the chassis. 2. Loosen 4 bolts (3) and locknut (4). 3.

Turn adjustment bolt (5) to move compressor (6) so that deflection (A) of the belt is 15 - 18 mm (0.6 - 0.7 in) (at a finger force of approx. 98 N (10 kg)). 4. After adjusting, tighten bolts (3) and locknut (4) NOTICE q Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. q In case any of the following occurs, ask the Komatsu distributor in your territory to replace the belts with new ones. The fan belt has elongated, leaving little allowance for adjustment. A cut or crack is found on the belt. Slipping or creaking sound is heard coming from the belt.

q When the new V-belt is set, readjust it after one hour of operation. 4-53