Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE 4 1. Open the engine side cover on the right side of the machine body, and remove filter cover (1) from the lower section. 2. Screw in valve (2) at the top of the corrosion resistor. 3. Using the filter wrench, turn cartridge (3) counterclockwise to remove it. 4. Apply engine oil to the sealing surface of a new cartridge, then install it to the filter holder. 5. When installing, screw in cartridge until seal comes in contact with sealing surface, then tighten approx. 2/3 turn. 6. Open valve (1). Use Komatsu genuine cartridge.

REPLACE POWER TRAIN OIL FILTER ELEMENT 4 The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Open cover on the right side of the machine. 2. Remove mounting bolts (2) of filter (1), then remove cover (3). 3. Remove the cover (4) under the fender, loosen drain plug (P), and drain the oil inside the filter case. 4. Take out element (5). 5. Clean the removed parts and the inside of the case, then install a new element. Use Komatsu genuine element. 6. Set so that the side hole of cover (3) is in the direction to match hole (A) of filter case (1), then tighten with bolts (2). 7.

Install drain plug (P). 8. Loosen air bleed plug (6), start the engine, and when oil spurts out, tighten the plug. 9. Close the cover at right side of machine. 4-57 WARNING