MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN DAMPER CASE 4 q The parts and oil is very hot just after the operation. Wait until the oil temperature drops, then start the work. q The undercover is heavy. Never try to open or close the cover when directly beneath it. When removing bolts(2), carry out the work from the rear of the cover so that you can easily get out of the way. q When removing drain plug (5) of the damper case, take care not to get oil over yourself. q Quantity of replacement oil: 1.3 liters (0.34 US gal) 1. Remove the undercover from the rear bottom of the machine body as follows. 2. Remove two bolts (1) from the front side of the machine body. 3.
Holding the cover, remove two bolts (2) from the rear side of the machine body. 4. Lower and open the cover gradually. Weight of undercover: 21 kg (46 lb) (A) Front of machine (B) Dangerous place 5. Remove oil level plug (3) and oil filler plug (4), then remove drain plug 5 to drain the oil. After the all oil is drained, tighten plug (5). 6. Add oil through the hole of oil filler plug (4) until the oil level reaches the bottom edge of the hole of oil level plug (3). 7. After refilling the oil, tighten plugs (3) and (4). 4-65 WARNING