© 0884 Guide to this Manual Section: 1 Page: 1-0-03 Engine: S/BVM 628 1.6 Job Card No. In addition to the Filing No., each card is provided with a Job Card No. Typical Job Card No.: 01.02.03, where: 01 = Maintenance Group = cylinder head 02 = Subassembly = rocker arm bearings 03 = Serial No. of card 1.7 Standard Tools Standard tools are those tools which are normally included in a workshop tool box. Hammer Chisel 1 set of box wrenches 1 set of ordinary wrenches Screwdriver Small water tube pliers Nippers Combination pliers Scriber Tape rule Various files Iron saw Centre punch Mandrel Socket-head wrench Hex.
wrench Three-square scraper Non-fraying rags Wire brush Grease gun Rubber mallet 1.8 Special Tools Special fitting tools and devices, normally supplied along with the engine, are listed in the associated Spare Parts Catalogue under the Assembly Group No. 49. 1.8.1 These tools are available from your local Deutz distributor.