© 0484 Job Card No.: 01.07.01 Page 2 of 2 Valve Seat Ring and Valve Cone Engine: S/BVM 628 Filing No.: 0178-08-297 6506 245 Exhaust valve 205 Inlet valve 285 Exhaust valve 215 Inlet valve befor reworking © 50 659 0 - in the areas X and Y - no interruption of the (shiny) chrome layer - between the zones X and Y (Fig on Page 2) - no corrosion pittings deeper than 0,2 mm, - stem diameter at no point 0,1 mm. Checking valve-seat rings The seat rings can be re-used if the following pre- conditions are fulfilledi: - Seats free from burnt spots, blow-bys, cracks or pounding marks. The seat surface of the seat rings is to be reworked in installed condition - in the cylinder head - if:
- the cleaned surface is not free from carbon scars, blow-bys, pittings, scorning, shoulders (see Fig.), corrosion and other damage (check with mag- nifying glass) In the case of corrosion damage to the inlet valve seat rings, check also the charge air pipe for salt deposits and corrosion and the charge air cooler for leaks (see Job Card 06.02.01). Reconditioning This reconditioning work may only be done by DEUTZ Service workshops which are especially equipped to carry out such work. © 51 240 0 245 Exhaust valve 205 Inlet valve 285 Exhaust valve 215 Inlet valve befor reworking © 50 659 0 © 50 6 59 0 © 51 240 0 © 51 2 40 0