©1084 Big-end Bearing Refitment Job Card No.: 02.06.01 Page 1 of 2 Engine: S/BV 6/8/9 M 628 Filing No.: 0178-06-10 1088 Inspect shells for wear pattern and renew, if Job Cards: required (job 02.04.01). Used shells, caps and - 02.03.03 bolts must always be refitted in their original - 02.14.01 location. Shells, caps, connecting rods and - 02.15.01 pistons carry mating Nos. (cylinder No.). Inspect condition of crankpin. It should not be Tools: out-of-round for more than 0,1 mm. - Standard tools, - possibly square timber, Job: Carefully clean crankpin, top shell (1) and big-end (8).
Carefully inspect pin surface and smoothen with an oil stone any pressure marks that may have been produced in removing the bearing. Bearing Refitment with Piston Removed Install piston (Job Card 02.14.01) and lower it until shell can be fitted. Check markings "x" and "y". Apply oil to running surfaces of shell and pin, but keep shell back and joint free from grease and oil to ensure perfect heat transfer. Top and bottom shells being identical, make sure that they are refitted in their original location. Make sure that lugs (3) of top and bottom shells properly engage in the rod/cap grooves. Now slowly lower piston/rod assembly down to crankpin.
Ensure that the lugs (3) of the top and bottom shells correctly engage in the rod/cap grooves. Slowly lower connecting rod with the piston onto the crankpin. © 51 396 0 © 51 396 0 © 51 396 0