© 0985 Crankcase Relief Valve Job Card No.: 03.01.01 Engine: S/BVM 628 Filing No.: 0178-01-10 1101 Inspection Tools: Inspect gaskets of crankcase doors and test relief - Standard tools valves. Following removal of doors (1) with valves (4) inspect liner seals between water jackets and crankcase interior. Prime lubricating circuit and check that all bearings are supplied with oil. Clean oil sump from any sludge. Job: Unscrew hex. bolts (3) and remove door (1) with relief valve (4). Press valve by hand from inside and release. If disk plate (6) jams when pushing or if the screw spring (10) prevents the plate from pressing back against the 0-seal (7), dismantle and clean the relief valve.
Servicing Dismantling the aRelief Valve Unscrew hex. bolts (14) and remove sealing rings (13). Unscrew cheese-head screws (9) and remove round flange gasket (11) and ring carrier (8) with 0-seal (7). Disk plate (6) and spring(10) are beared in relief valve housing (4). Replace any defective part. Before reassembling, check round flange seal (11), gasket (2), and 0-seal (7) and replace, if required. Tighten hex. bolts (3). © 25 229 1 © 25 229 1 © 25 229 1