Deutz — 04.02.01 Lower Valve Drive

© 1285 Lower Valve Drive Job Card No.: 04.02.01 Page 3 of 3 Engine: S/BVM 628 Filing No.: 0178-11-10 1346 Removing Tappet Roller After removing the complete tappet (29), the roller can be removed. The best way to do this is to use a prism, on which the tappet is placed to press out the roller pin (32) - Fig. 3 -. If no prism is to hand, the tappet can be placed on a hard-wood block (33) or on an aluminium plate provided with a suitable large hole for free passage of the roller pin when being pressed out.

Before pressing out the pin by means of a brass drift and a press, place a 0,3 - 0,4 mm-thick plate (34) between both sides of tappet (29), in order to prevent possible deformation of the lower part of the tappet. © 50 117 1 Fig. 3 Refitting the Drive Clean all drive components, apply some oil and assemble in the reverse order. Check tappet roller (31) for easy rotation. Install tappet guide (30) provided with a new 0-seal (14) along with tappet (29) into crankcase, paying attention to dowel sleeve (15). Slit of dowel sleeve (15) must face longitudinal direction of engine. Screw in bolts (16) provided with lockwashers (17) and tighten securely.

Check that tappet (29) moves freely in guide (30). Install pushrods (25) and refit cylinder head (Job Card 01.09.01). Set valve clearance (Job Card 01.01.01) . Hint for Faciliating Removal of Camshaft The cylinder heads can remain in situ. Only the pushrods (25) neeed be removed. By means of weld ing wires, the tappets (29) can be raised and the camshaft removed as perJob Card 04.05.01. At the upper edge of the tappet (29) is a bore-hole, into which a wire can be inserted. Then raise the tappet and suspend it at the top edge of the cylinder head. © 50 117 1 © 50 117 1