Valve Timing Checking Job Card No..: 04.06.02 Engine: S/BVM 628 Filing No.: 0178-10-10 1113 Checking Tools: - Standard tools Check inlet/exhaust valve timing. - Tape rule A timing check is required following camshaft fitment (Job Card 04.06.01) and when inspec- ting or working on the timing gears. Job: Check valve clearance (Job Card 01.01.01). Turn crankshaft in the normal running direction until the valve drive of No. A1/1 and B1/7 or 9 cylinders have frictional contact so inlet/exhaust pushrods are heavy to turn.In this position mark flywheel to agree with the fixed pointer on the crankcase. From this mark to the TDC mark of No. 1 cylinder (in-line engines) or No.
A1/B1 cylinder (V-type engines) measure distance "b" on flywheel periphery and flywheel diameter. 360 x b α = d x π where b = distance on periphery and d = diameter. The value obtained for must conform to the timing data (Section 3.3.1) within + 4° crank angle, otherwise inspect upper and lower valve drives (Job Card 04.02.01) and timing gears (Job Card 04.08.01).