Job Card No.: 05.04.14 Page 12 of 12 Barber-Colman plus 8 Electronic Governor Linkage Setting Engine: S/BV 9 M 628 Filing No.: 0178-29-10 1811 14. After the engine has been put back to service and final load setting has been made, check that the governor scale gives the following readings: No load = 9° rotation measured from Full load = 34° rotation Stop position Failing this, adjust linkage (points C8 or C10 under 11.). 15. Setting the starting fuel limit: While the engine is running at 11 bar b.m.e.p., pressurize air cylinder of fuel limit and adjust refitted lever so that there is contact at point (**) - Fig. 19 - . Tighten screw (*), depressurize air cylinder.
After finally completing the settings, refit the covers at points A22, A25, A23 and A26 - Fig. 1 -, together with new gaskets, if necessary. Remount the linkage covers. © 24 940 1 Fig. 19 © 24 940 1 © 24 940 1