© 0885 Exhaust Manifold Job Card No.: 06.01.01 Page 1 of 3 Engine: S/BV 8 M 628 Filing No.: 0178-41-10 1986 Inspection Tools: - Standard tools When the cylinder head is due for servicing (job - Lubrificating compound „Deutz S1“ 01.08.01), inspect the manifold for leaks and conta- (Section 3.6) mination inside, see also job 06.01.03. If heavy de- - Brush posits of soot are inside, remove and clean manifold. Job Cards: Job: - 01.08.01 - 06.01.03 Check manifold for leaks. Leaks due to cracks or slack bolting are usually indicated by black discolou- ring or carbon black/soot deposits at the ventilation slots of the legging.
Remove part of legging involved for sealing/tightening up leaks and replacing gas- kets, expansion joints or manifold sections. Check that all bolts are tight. Where the entire legging has been removed, be sure to refit all cover plates, especially the strip covering the ventilation slot at the top. Failing this, operating media (fuel or oil) may find ingress into the legging, e. g. from leaks of adjacent piping. If the entire exhaust manifold has been removed, it is necessary when reassembling to observe correct allocation of individual cylinders to the manifold sec- tions, as shown in Fig. 2 and 3. When refitting expansion compensators, ob- serve the direction of flow.
The bead-over of the inner pipe and the wide overlap of the flange must be on the flow approach side (see Fig. 1). When reassembling the exhaust manifold, be sure to use the right, partly heat-resistant bolts and nuts, as listed in the spare parts book. Installed length © 25 252 1 Fig. 1 Installed length © 25 252 1 © 25 252 1