© 0885 Exhaust Manifold Job Card No.: 06.01.01 Page 3 of 3 Engine: S/BV 8 M 628 Filing No.: 0178-41-10 1986 © 50 043 1 Fig. 4 Mount fillers at the ends of the exhaust manifold sections as per Fig. 4. The marking groove is always situated opposite to the exhaust inlet of the upper cross pipe of the T- shaped exhaust bend, as shown. Boltings of the exhaust gas system which are subject to thermal stress loads have to be coated with protective lubricating compound ”Deutz S1” to facilitate later dismantling. To do this, clean boltings thoroughly, then apply thin coat of compound using brush, or, if available, a spray can. © 50 043 1 © 50 043 1