Deutz — 07.01.01 Injection Pump Locking Control Rod Inspection

© 1284 Injection Pump Locking Control Rod Inspection Job Card No.: 07.01.01 Page 1 of 2 Engine: S/BVM 628 Filing No.: 0178-17-10 1947 Inspection Job Card: Check injection pump control rod for movement. - 05.00.01 Located in the injection pump top are the individual plug-in elements, the plungers of which are driven by the injection pump cams- haft via roller follower tappets. Positive plunger/tappet contact is ensured by a spring. The control rod 310 - Fig. 1 - is fitted with a lug (3) which engages with the control pin (21) of the pump element and thus transmits the governor action to the plunger provided with a helical control edge.

Job Checking the Control Rod for Free Movement Observe safety precautions as per Job Card No. 05.00.01. Proceed by moving the rod by hand with the engine stopped and the engine control lever in the ”Run” position. If provided, actuate shutdown button on speed governor and press the control linkage bet- ween governor and injection pumps in the direction ”Max. fuel”. Resistance should be offered by the governor only. Should lack of free movement be found, remove cover (1) and press the control linkage again. If all of the control pins (21) move uniformly to and fro, check the control linkage between governor and injection pump, as per Job Card 07.02.03.

If a plunger sticks, renew the pump element (Job Card 07.02.01). © 25 533 1 Fig. 1 © 25 533 1 © 25 533 1