© 1284 Idle Stroke Setting Job Card No.: 07.02.02 Page 1 of 2 Engine: S/BVM 628 Filing No.: 0178-17-10 1955 Setting Job Card: - 07.02.01 Prior to installing a pump element, it is necessary to carry out a basic setting of the idle stroke. Tools - Standard tools - Depth gauge Job Turn engine by barring gear until the relevant tappet roller rests on the cam base circle. To facilitate gau- ging, insert a bush (b) - Fig. 1. Using depth gauge, measure dimension (a) and calculate dimension (t). t = a - b Now turn the engine until the tappet roller of the relevant pump element rests on the cam peak - Fig. 2. Mount retainer device (1). This retains the support (15).
Turn engine further until the roller is again re- sting on the cam base circle. © 25 548 1 Fig. 1 © 25 548 1 © 25 548 1