Deutz — 07.03.02 Fuel System Bleeding

© 1184 Fuel System Bleeding Job Card No.: 07.03.02 Engine: S/BVM 628 Filing No.: 0178-20-10 1847 Servicing Tools: - Standard tools Before using reconditioned (overhauled) or new in- - Claw grip spanner with tommy bar jection pumps, or following fitment of fuel piping, (Section 1.8) filter or overflow valve, the entire fuel system must be filled up with fuel and bled. Job Bleeding the Low Pressure System - Fig. 1 Stop engine. Place control rod of injection pump in full-load position. (Engine control lever in ”Run” posi- tion.) Open shut-off valve in fuel line to engine. Switch 3-way cock (7) at fuel filter to middle position and unscrewing screws (5). Remove cover (4).

Open bleed screws (3) by 1 or 2 threads. With hand pump or standby feed pump prime system until fuel emer- ges free from bubbles at the bleed screws. Retighten bleed screws. Refit cover and secure by wing screws. Switch 3- way cock to right or left position. © 24 964 1 Fig. 1 Bleeding the High Pressure System - Fig. 2 Loosen union screw (1) by 1 to 2 turns, so that inner seal will not be damaged. Loosen union nut (2) also by 1 or 2 turns, using claw grip spanner and tommy bar. Afterwards, place control level several times briefly to ”Run” position until fuel emerges at the passage of the injection pipe through the cylinder head. Tighten injection pipe connection (see Section 3.5, item 31).

Finally, lightly tighten union screw (1). © 24 965 1 Fig.2 © 24 964 1 © 24 964 1 © 24 965 1 © 24 965 1