© 0988 Injection Pump Removal / Refitment Job Card No.: 07.04.01 Page 3 of 8 Engine: S/BV 6/8/9 M 628 Filing No.: 0178-18-10 2059 Before refitting injection pumps G Make sure that only genuine DEUTZ gaskets are fitted under crankcase covers - behind injection pumps - and spacers (25) - Fig. 3 - otherwise alignment errors may result. Refitting pump 1 (6/8/9-cyl. engine) G Fit shaft (14) - Fig. 2 - by locating it with dowel pin (22) and screw together with washers (23) and cheese head bolts (7) until hand-tight. If the injec- tion pump retainer had been taken off, it should be suspended loosely above the shaft. If not, loosen the four hex. bolts (101) - Fig. 5 - before refitting the pump.
© 50 291 1 G Insert bushes (2) - Fig. 2 - into shaft (14) and Fig. 5 thread fitted bolts (8) provided with bushes (3) through shaft (14). Connect washers (9), coupling disc (5) - recessed side facing towards drive end - and connecting plate (4) with fitted bolts and screw together until hand-tight. G Make sure that spacers (25) are fitted - Fig. 3. Place injection pump with shaft onto parallel pin in crank- case cover and observe marks (11) - Fig. 5 -. Secure hex. bolts (20) provided with washers (21) hand-tight so that the injection pump rests against the crankcase without any clearance.
If space is limited, it is also possible to screw shaft (14) together with the injection pump only when this is already loosely attached to the crankcase. © 50 291 1 © 50 291 1