© 1283 Injection Timing Job Card No.: 07.06.01 Page 1 of 2 Engine: S/BV 6/8/9 M 628 Filing No.: 0178-17-10 1157 Injection Timing Tools: (Setting the Commencement of Injection) - Standard tools Following any work on the injection pump drive, test - Spill pipe the commencement of injection on the pump ele- - Injector testing outfit (Section 1) ment for the No. 1 cylinder. - Pipe from testing pump to fuel filter - Torque wrench Adjusting the commencement of injection and hence the firing pressures is permissible only Job Card: when the pressures depart from the Accep- - 07.03.01 tance Certificate.
Such fault may be due to excessive backlash of the injection pump drive gear, coupling out of adjustment, wear in the injection pump drive, excessive backlash of pump drive gear. An advancement of the commencement of injection raises the firing pressure and vice versa. Prior to any adjustment of the setting, check that injector, injection pipe and injection pump are in good shape and condition. An adjustment as described hereafter ensures utmost accuracy since the measurement involved considers any wear both in the pump drive and the actual pump. Job: Setting the Commencement of Injection at the Injection Pump Coupling Stop engine. Place control level in “run” position.
Shut off fuel suction line between engine and fuel service tank and between overflow line and injection pump (1). Unscrew bleed plug on fuel filter (2). Fit banjo bolt with pipe (3) (see under “Tools”) to filter and connect pipe (3) to testing pump (4). Disconnect injection line (5) for No. 1 cylinder from injector, connect spill pipe (6) and place container (7) thereunder. Turn engine until roller tappet of No. 1 cylinder rests on the cam base circle. Operate testing outfit until fuel emerges in a vigorous jet. While pumping, slowly turn engine in the normal running direction.
Once the fuel jet breaks, stop turning and pumping because at this point the commencement of injection is properly set according to the acceptance documents. Failing this, re-adjust (see page 2). If you continue pumping, this may result in damage to the fuel L.P. system. Measure distance “b” on the flywheel periphe- ry from No. 1 cylinder TDC mark to the fixed arrow on the crankcase. Convert this value to degress crank angle and compare with the Acceptance Certificate. © 51 406 0 Fig. 1 © 51 406 0 © 51 406 0