© 0784 Job Card No.: 07.07.01 Page 2 of 2 Injector (Uncooled) Removal / Refitment Engine: S/BVM 628 Filing No.: 0178-19-10 1637 Refitting the Injector: Apply light film of Deutz S1 heat-resistant lubricating compound to new washer (29) and its seat, as well as to sliding surface of nozzle (15). Fit washer on injec- tor. If necessary, fit new O-seals 2 and apply light film of Deutz F5 compound. Install injector with the aid of dowel pin (30). Clean joints of injection piping. For fitting the injection piping, see job 07.03.01. Then fit clamping pad (23) along with domed washer (24). Next, tighten hex., nut (22) as specified (Section 3.5, item 23).
Mount rocker chamber cover, bleed fuel system (job 07.03.02). © 51 319 0 © 51 319 0 © 51 319 0