Deutz — 08.09.01 Oil Filter Combination (Non-Backflushing Wire Edge Filter)

© 1083 Job Card No.: 08.09.01 Page 2 of 2 Oil Filter Combination (Non-Backflushing Wire Edge Filter) Engine: S/BVM 628 Filing No.: 0178-15-10 6507 G Undo hex. nuts (9) - Fig. 2 - with withdraw edge filter element (14) from filter body. G Remove square flange gasket (8). To prevent dirty cleaning fluid from getting inside the element, close open end with a cap of 55 mm dia. G Dip element in diesel fuel, actuate rotary knob (5) alternately and clean element with the brush. G Remove cap and blow out element from inside with filtered compressed air. If the filter wire is damaged or dented, renew the element. G Plug up oil outlet hole (4) - Fig. 3 - in filter body. G Clean filter chamber.

Remove plug after cleaning. G Insert drain plug (3) - Fig. 2 - along with washer (2). G Refit filter element (14) with new flange gasket (8) in filter body. G Tighten hex.nuts (9). Introduce filter element (14) in perfectly horizontal position so that it will not be damaged. © 51 330 0 Fig. 2 Filter element © 51 331 0 Fig. 3 Lube oil outlet hole © 51 330 0 © 51 330 0 © 51 331 0 © 51 331 0