© 0883 Specification Data Section: 3.8 Page: 3-6-01 Engine: S/BVM 628 3.8 Dye Checking of Metal Surfaces The dye checking process for detecting metal surface flaws requires the following agents: Detergent (trichlorethylene), Diffusion fluid (red), Developer(white) Cleaning the part - Apply the detergent at least one hour before applying the diffusion fluid to ensure that any grease is removed from the metal surface and its flaws (cracks, fissures, etc.) (Fig. 1) (see safety in- struction, page 3-6-02) Applying the diffusion Fluid - Apply fluid by spraying gun, hair brush or by dipping part into the directionsfor use (Fig. 2).
- Wash off surface by water, so fluid will remain in the flaws only (Fig. 3). - Wipe surface clean with a dry rag. Applying the developer - Once the surface is dry, apply on a thin film of developer by spray gun or hair brush. - Let developer dry for one or two minu- tes. - The "blotting paper effect" of the white developer will make the red fluid beco- me visible in the flaws (Fig. 4). © 25 459 1 © 25 459 1 © 25 459 1