Deutz — 12.01.01Viscous-type Vibration Damper (Version without Auxiliary Drive)

© 1283 Viscous-type Vibration Damper (Version without Auxiliary Drive) Job Card No.: 12.01.01 Engine: S/BVM 628 Filing No.: 0178-34-10 1337 Replacement of this torsional vibration dam- Tools: per is due at the end of 15,000 running hours. - Standard tools Reconditioning must be made by the manu- - 2 puller bolts M12 x 70 facturers only. - Hoist Job: Removing the Damper Stop the engine. Remove casing. Attach damper (3) to hoist. Remove bolts (1) with washers (2). Use bolts (4) to pull off damper 3 from crankshaft (5). Clean all damper contact faces. Remove any high spots with oil stone. Refitting the Damper Remove puller bolts (4).

Clean crankshaft journal as well as the contact faces of the new damper and balance weights (3) and push balance weights with damper onto the crankshaft journal (5). Ensure that damper and balance weights are centred. Screw in screws (1) with washers (2) fingertight. Tighten screws crosswise as specified (Section 3.5, item 48). Refit casing. © 51 373 0 © 51 373 0 © 51 373 0