© 0686 Rubber-type Vibration Damper Inspection / Reconditioning Job Card No.: 12.01.02 Page 1 of 4 Engine: S/BVM 628 Filing No.: 0178-34-10 1849 The torsional vibration occurring in the critical Tools: speed range of the engine is absorbed by two - Standard tools or four rubber damping elements secured - Pocket lamp between fly ring and the plates attached to Job Card: the crankshaft flange. - 12.01.03 Keep fuel and lube oil away from rubber ele- ments! Inspection Inspection is carried out with damper in situ. G Check air slits (if provided) in damper for cleanliness and free air-passage. If necessary, clear slits with compressed air.
G Where possible, check damper elements for freedom from cracks and for firm connection with the vulcanized-on steel plates. If necessary, recondition damper. G Check bolts of joints (where accessible) for “hand-tight” seating (torque ca. 30 Nm), without holding the nuts. Any signs of friction indicate loose bolts. If loose bolted joints are found, the damper has to be reconditioned. Reconditioning The damper must be reconditioned not later than 10 years after date of engine commissioning, irrespective of the hours run. Such reconditioning is required too, if damage or any defects have been ascertained during the inspection.
We recommend that reconditioning be entrusted to a DEUTZ-Service workshop.