Deutz — 4.2 Running the Engine on Distillate Fuel

© 0185 Operating the Engine Section: 4 Page: 4-1-01 Engine: S/BVM 628 4.2 Running the Engine on Distillate Fuel Item Procedure A B C Reference 1 Open indicator valves G G G 2 Turn engine over twice by barring gear, but not later than 1 hour after prelubricating, otherwise repeat prelubricating G G 3 Place speed control in lowest possible position G G Section 3.3.1 4 Keep assistance ready at the emergency stop drive G G Job 05.00.01 5 5 With air receivers closed, move engine control lever from "Stop" to "Start" position. Slowly open air shut-off valves and - with indicator valves opened - briefly turn engine over.

Close air receivers, move control lever back to "Stop" position and close indicator valves G G G 6 Open air receiver fully G G G 7 Move local control lever from "Stop" to "Start" position and - when firing speed is attained - move on to "Run" position G G G Section 3.3.1 8 Should the engine fail to fire at the end of some 3 seconds, wait for a while and repeat starting attempt. If several such starting attempts are unsuccessful, trace cause of trouble and remedy.

G G G Section 7 9 Switch off water preheater (if provided) at temperature specified G G G Section 3.3.2 10 Where the standby lube oil pump is used for priming, switch off pump once idling speed is reached or when the starting inhibitor, if provided, releases G G G 11 Raise engine speed slowly G G