Deutz — 4.4.1 Stoppage / Layoff of Engine Running on Heavy Fuel or MDF Blend

© 0885 Operating the Engine Section: 4 Page: 4-3-03 Engine: S/BVM 628 4.4.1 Stoppage / Layoff of Engine Running on Heavy Fuel or MDF Blend A Short Period (Engine remains readily available) B Prolonged Period C Period exceeding 3 months Item Job A B C 1 When operating with blended fuel G G When operating with blended fuel > 380 mm2 /s (cSt) / 50° C , the engine must be run for at least 1 hour with distillate fuel before shut-down - longer than 72 hours - until the fuel system is completely filled with distillate fuel. 2 To prevent heat accumulation, let engine idle for 5 minutes or so before shutting it down from prolonged full-load service.

Where separate oil and coolant pumps are provided, keep them going for 5 minutes following shut-down. G G G 3 Stop engine G G G 4 Switch off viscosity control, injector coolant pump, fuel feed pump and fuel plunger sealing oil pump G G 5 Close shut-off valve of air receiver G G 6 Close shut-off valve of fuel service tank G G 7 Close shut-off valves before and after water cooler G G 8 When frost is imminent, switch on water preheater, unless an anti-freeze has been added, or drain all water from engine and attachments (see Job 09.00.01) G 9 Drain all water from engine and attachments (see Job 09.00.01) G