OPERATION 2.19 Reset function 3. Heating and ventila- tion Operation_Pic_number:1 3.1 Heater with 3-speed blower Operation_Pic_number:1 Fig.35 Reset - initiate function. Press clutch pedal. Press push button (A). Fig.36 To end Reset function. Stop the tractor. Switch ignition OFF/ON. The heating depends on the water temperature. Text-module Switch on fan (control knob A). Fan off. When a reset is made, the following are re- stored to their basic settings. Cruise control (Memory 1 - final speed, Me- mory 2 - 10 km/h). Load limit control (14% reduction to rated speed). Valves (valid for all valves - lift 30 l, lower 30 l, time 10 seconds, floating position ac- tive).
Rear lifting gear (upper limit 100% up, Trac- tion/Position control 100% Position, lowering speed 50%). Comfort front power lift (upper limit of tra- vel 100% up, lifting speed 30 l, lowering speed 5 l). Fan speed 1. Blower speed 2. Blower speed 3. Directing the air stream (control knob C). Air outlet nozzles closed. through air vents in the footwell. through air vents in the footwell and in front of the windscreen. through air outlet nozzles in front of windshield, recirculated air mode on at the same time. Text-module Switching on the heater (control knob B). The control knob is ued to switch the cab heating on/off, and for stepless adjustment to the desired temperature. NOTE:
If operating the air conditioning, set all con- trol knobs to '0'. 31