Freightliner — Business Class

Brakes 42 42–01 Air Dryer Inspecting, Bendix AD–9 tured unit. Repeat the leakage checks before placing the brake valve in service. 42–03 Foot Brake Valve Actuator Lubricating, Bendix E–12 1. Check the reservoirs for moisture. A small amount (teaspoon or less) is normal. Larger amounts may mean that the desiccant needs to be replaced. Check the mounting and connecting lines. 1. Clean any dirt, gravel, and other foreign debris from the plunger boot and brake base bracket. 2. Tighten the fasteners attaching the air dryer to the vehicle. Use the following torque values. 2. Check the brake plunger boot for cracks, holes, or deterioration. Replace if necessary.

28 lbf·ft (38 N·m) for SAE grade 5, 3/8–16 fas- teners. 3. Lift up the edge of the brake plunger boot and check the plunger for existing lubrication. If the plunger is dry, remove it by removing the cotter pin from the clevis pin and pulling the clevis pin out. Remove the piston rod and boot. Lift out the plunger. Lubricate the plunger and the tip of the piston rod with barium grease part number BW 246671, or Penzoil Adhezoplex EP 2. Install the piston rod, boot, clevis pin, and cotter pin. 135 lbf·ft (183 N·m) for SAE grade 5, 5/8–11 fas- teners. Check all air lines, fittings, and electrical connec- tions for damage, leakage, or looseness. 3.

Replace damaged or leaking parts, and tighten loose fittings or electrical connections. 42–02 Air Brake Valve Inspecting and Leak Checking, Bendix BP–R1 If the plunger has grease on it, lift the edge of the brake plunger boot enough to apply 2 to 4 drops of light oil around the brake plunger. Do not over-oil. Install the plunger boot. 4. Lubricate the clevis pin with light oil. 1. Clean the valve exterior and inspect it for corro- sion and damage. 5. Check for leakage; see Group 42 of the Busi- ness Class ® Trucks Service Manual for instruc- tions. 2. Inspect the air lines connected to the valve for signs of wear or damage. Replace the lines as needed.

42–04 Air Brake Valve Operation Checking, Bendix BP–R1 and E–12 3. Check the valve for leakage. 3.1 Apply the service brakes and hold them on full line pressure of at least 80 psi (550 kPa). Check for proper operation; see Group 42 of the Business Class ® Trucks Service Manual. 3.2 Check the air line fittings for leaks; tighten or replace the fittings as needed. 42–05 Relay Valve Checking, Midland 3.3 Coat the exhaust port and body of the valve with soapy water, and check for leakage. Leakage is excessive if it pro- duces a 1-inch (25-mm) bubble within 5 seconds. Chock the tires.

Start the engine and run it long enough to pressurize the air system to at least 80 psi (550 kPa), then turn off the engine. If the brake valve does not function as described above, or if leakage is exces- sive, replace it with a new or remanufac- Repeat as necessary, to maintain 80 psi (550 kPa) pressure during this check. Business Class Trucks Maintenance Manual, October 1998 42/1