Komatsu — WALK-AROUND CHECK

OPERATION OPERATION OPERATION 0. NOTICE The following describes a machine with 2-lever control. For machines with multifunction lever, see MULTI- FUNCTION LEVER ( 6-45 ). CHECK BEFORE STARTING ENGINE, ADJUST 0. WALK-AROUND CHECK 0. Always attach the warning tag to work equipment con- trol lever (1). Leakage of oil or fuel, or accumulation of flammable material around high temperature parts, such as the engine muffler or turbocharger, may cause fire. Check carefully, and if any abnormality is found, repair it or contact your Komatsu distributor.

Before starting the engine, walk around the machine and look to the underside of chassis for anything unusual like looseness of the bolts and nuts, leakage of fuel, oil and cooling water. Also check the condition of the work equip- ment and the hydraulic system. Do not neglect the electric wiring then to see that there is no looseness, play or dust on the portion that generates high temperature. Always carry out the items in this section before starting the engine each day. 1. Check for damage, wear, play in work equipment, cylinders, linkage, hoses Check that there are no cracks, excessive wear, or play in the work equipment, cylinders, linkage, or hoses.

If any abnormality is found, repair it. 2. Remove dirt and dust from around engine, battery, radiator Check if there is any dirt or dust accumulated around the engine or radiator. Check also if there is any flamma- ble material (dead leaves, twigs, etc.) accumulated around the battery or high temperature engine parts, such as the engine muffler or turbocharger. Remove all such dirt or flammable material. 3. Check for leakage of water or oil around engine Check that there is no leakage of oil from the engine or leakage of water from the cooling system. If any abnor- mality is found, repair it. 4.

Check for leakage of oil from transmission case, axle, hydraulic tank, hoses, joints Check that there is no leakage of oil. If any abnormality is found, repair the location of the leakage. 5. Check for leakage of oil from brake line Check that there is no leakage of oil. If any abnormality is found, repair the location of the leakage. 6. Check for damage or wear to tires, loose mounting bolts Check for cracks or peeling of the tires and for cracks or wear to the wheels (side rim, rim base, lock ring). Tighten any loose wheel nuts. If any abnormality is found, repair or replace the part. If any valve caps are missing, install new caps. 3-67 WARNING