OPERATION OPERATION 3. When preheating pilot lamp (2) goes out, turn the key in starting switch (1) to the START position. The starting motor will be cranked and after the engine rotates under no load for 2 or 3 seconds, the engine will start. 4. After the engine starts, release the key in starting switch (1). The key will automatically return to the ON position. 5. After the engine starts, if the engine water temperature is low (below 20 °C (68 °F)), the warming-up operation (engine speed: 1130 rpm) is automatically carried out. For details, see “AUTOMATIC WARMING-UP OPERATION ( 3-82 )“.
REMARK Because of the turbo protect function, immediately after the engine starts, even if the accelerator pedal is depressed, the engine speed will not rise above 1130 rpm. The turbocharger rotates at extremely high speed. Immediately after the engine is started, the pressure of the lubricating oil has not risen sufficiently, so if the engine speed is suddenly raised, it may lead to damage or sei- zure of the turbocharger bearing. The turbo protect function acts to prevent this problem. It uses electronic control to prevent the engine speed from rising above a certain speed for the first few seconds after the engine started.
To improve the ease of starting in cold weather, the low idling speed becomes slightly higher for the time given below and the engine sound is different. In addition, it functions to make the acceleration gradual during this time. 3-81 Engine water temperature Turbo protect time above 20°C (68°F) 0 sec. -18°C to 20°C (-0.4°F to 68°F) 0 to 12 sec. Below - 18°C (-0.4°F) 15 sec. Engine water temperature Injection characteristics change time above 20°C (68°F) 0 sec 0°C to 20°C (32°F to 68°F) 0 to 6 sec -20°C to 0°C (-4°F to 32°F) 6 to 12 sec -30°C to -20°C (-22°F to -4°F) 12 to 15 sec