OPERATION OPERATION HANDLING THE TIRES 0. PRECAUTIONS WHEN HANDLING TIRES 0. CAUTION If a tire has reached any of the following service limits, there is danger that the tire may burst or cause an acci- dent, so to ensure safety, replace it with a new tire. Service limits for wear When the remaining depth of the groove on construction equipment tires (at a point approx. 1/4 of the tread width) is 15% of the groove depth on a new tire. When the tire shows marked uneven wear, stepped wear or other abnormal wear, or when the cord layer is exposed.
Service limits for damage When there is external damage extending to the cord or when the cord is broken When the cord is cut or there is dragging When the tire is peeling (there is separation) When the bead is damaged For tubeless tires, when there is air leakage or improper repair Please contact your Komatsu distributor when replacing the tires. It is dangerous to jack up the machine without taking due care. TIRE PRESSURE 0. Measure the tire pressure before starting operations, when the tires are cool. If the tire inflation pressure is too low, there will be overload; if it is too high, it will cause tire cuts and shock burst.
To prevent these problems, adjust the tire inflation pressure according to the table on the next page. Deflection ratio = H - h / H x 100 As a guideline that can be checked visibly, the deflection ratio of the front tire (deflection/free height)is as follows. When carrying normal load (lift arm horizontal): Approx. 15 to 25 % When digging (rear wheels off ground): Approx. 25 to 35 % When checking the tire inflation pressure, check also for small scratches or peeling of the tire, for nails or pieces of metal which may cause punctures, and for any abnormal wear. 3-114