OPERATION TRANSPORTATION SECURING MACHINE 0. Load the machine on to a trailer as follows. 1. Lower the blade slowly. 2. Apply the safety lock to lock all the control levers securely. 3. Turn the starting switch to the OFF position to stop the engine, and pull out the starting switch key. 4. Lock front frame and rear frame with safety bar. 5. Put blocks in front and behind the wheels, and secure the machine with chains or wire rope to prevent the machine from moving during transportation. In paticular, fix the machine securely to prevent it from slip- ping sideways. 6. Always retract the car radio (option) antenna fully. UNLOADING 0. 1.
Perform loading and unloading on firm, level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert blocks under the tires to ensure that the trailer does not move. Then fix the ramps in line with the centers of the trailer and the machine. Be sure that the two sides are at the same height as one another. Make the angle of the ramps a maximum of 15є. Set the distance between the ramps to match the center of the tires. If the lamp sags appreciably, reinforce it with blocks, etc. 3. Remove the chains or wire rope holding the machine. 4. Start the engine. Warm the engine up fully. 5. Set the safety lock lever to the FREE position.
6. Determine the direction of the ramps, then drive the machine slowly down the ramps to unload the machine. 3-117