Komatsu — LIFTING PROCEDURE

TRANSPORTATION OPERATION LIFTING PROCEDURE 0. When the machine is raised, check that there is no leakage of oil from the hydraulic circuits of the machine. When carrying out the lifting operation, please contact your Komatsu distributor. Lifting work can be carried out only for machines with lifting marks. Before starting the lifting operation, stop the machine in a horizontal place and do as follows. 1. Start the engine, make sure that the machine is horizontal, then set the work equipment to the travel posture. For details, see “PREPARATIONS FOR MOVING MACHINE ( 3-86 )“. 2. Move the work equipment safety lock lever to the LOCK position. 3.

Stop the engine,check that the area around the operator‘s compartment is safe, then lock with the safety bar so that the front frame and rear frame do not articulate. 4. Fit the lifting equipment to the lifting hooks (marked by the lifting mark) at the front of the front frame and the rear of the rear frame. For machines equipped with a rear full fender, remove the rear full fender before carrying out out the operation. 5. When the machine leaves the ground, stop for a moment and wait for the machine to stabilize, then continue the lift- ing operation slowly. 3-120 CAUTION