Komatsu — CHASSIS

TROUBLESHOOTING OPERATION CHASSIS 0. ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs. Transmission Axle Brake 3-134 Problem Main causes Remedy Engine is running but machine does not move •Parking brake is applied •Directional lever is not shifted properly •Lack of oil in transmission case •Release parking brake •Shift lever properly •Add oil to specified level. See WHEN REQUIRED Even when engine is run at full throttle, machine only move slowly and lacks power •Lack of oil in transmission case •Screen is clogged •Add oil to specified level.

See WHEN REQUIRED (•Disassemble, clean) Oil overheats •Too much oil or too little oil •Machine is not traveling in correct speed range •Torque converter is stalled for long periods •Engine is overheating •Add or drain oil to specified level. See WHEN REQUIRED •Place in correct speed range •Reduce stall time (•Check engine) Noise generated •Lack of oil •Add oil to specified level. See WHEN REQUIRED Noise generated •Lack of oil •Improper oil used (for machines with anti-slip differential) •Add oil to specified level.

See WHEN REQUIRED •Change to specified oil Brake is not applied when pedal is depressed •Disc has reached wear limit •Defective hydraulic system • Lack of oil •Air in brake line (•Replace disc) •Add oil to specified level. See EVERY 100 HOURS •Bleed air See WHEN REQUIRED Brake drags or remains applied •Vent hole of brake valve is clogged •Clean Brakes squeal •Disc is worn •Large amount of water in axle oil •Deteriorated axle oil due to over- use of brake (•Replace disc) •Change axle oil •Change axle oil