MAINTENANCE OUTLINES OF SERVICE GREASE 0. Grease is used to prevent twisting and noise at the joints. The nipples not included in the maintenance section are nipples for overhaul, so they do not need grease. If any part becomes stiff after being used for long time, add grease. Always wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. CARRYING OUT KOWA (Komatsu Oil Wear Analysis) 0. KOWA is a maintenance service that makes it possible to prevent machine failures and down-time. With KOWA, the oil is periodically sampled and analyzed.
This enables early detection of wear of the machine drive parts and other abnormalities. Periodic use of KOWA makes the following possible: It enables abnormalities to be detected early, leading to reduction of repair costs and machine downtime. It enables repair schedules to be planned, leading to improved machine availability. KOWA analysis items 0. Analysis of metal wear particles This uses an ICP (Inductively Coupled Plasma) analyzer to measure the density of metal wear particles in the oil. Measurement of particle quantity This uses a PQI (Particle Quantifier Index) measurer to measure the quantity of large iron particles in the oil.
Others Measurements are made of items such as the ratio of water or fuel in the oil, and the dynamic viscosity. Oil sampling 0. Sampling interval 250 hours: Engine 500 hours: Other components Precautions when sampling Make sure that the oil is well mixed before sampling. Carry out sampling regularly at fixed intervals. Do not carry out sampling on rainy or windy days when water or dust can get into the oil. For further details of KOWA, please contact your Komatsu distributor. 4-5