SERVICE PROCEDURE MAINTENANCE CHECK TRANSMISSION OIL LEVEL, ADD OIL 0. The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. Carry out this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the cooling water. 1. Start the engine and run it for at least 5 minutes. 2. Open the cap of oil filler port (F), remove dipstick (G), and wipe the oil off with a cloth. 3. Insert dipstick (G) again from the top of the oil filler port diagonally as shown in the diagram, then pull it out again.
When doing this, insert the dipstick so that the tip contacts the bottom of the dipstick guide. 4. The oil level should be between the H and L marks on dip- stick (G). If the oil level is below the L mark, add engine oil through oil filler (F). 5. If the oil is above the H mark, drain the excess engine oil from drain plug(P), and check the oil level again. 6. If the oil level is correct, insert dipstick (G) in the dipstick guide, then tighten the cap 4-24 WARNING