Komatsu — CHECK ALTERNATOR BELT TENSION, ADJUST

MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR BELT TENSION, ADJUST 0. CHECKING 0. The standard deflection between the alternator pulley and crank pulley when pressed with a thumb (approx. 59N (6 kgf)) should be approx. 13 mm (0.5 in). ADJUSTING 0. 1. Loosen bolts and nuts (1), (2), (3), and (4). 2. Turn nut (5) clockwise and move alternator (6) so that the deflection of the belt is approx. 13 mm (0.5 in)(approx. 59N (6 kgf)). 3. Tighten bolts and nuts (1), (2), (3), and (4) to hold alternator (6) in position. 4. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. Be particularly careful to check that the V-belt is not in contact with the bottom of the V-groove. 5.

If the belt has elongated and there is no more allowance for adjustment, or if the belt is cut or cracked, replace the belt. 6. After replacing the belt, operate for one hour, then adjust again. 4-43