Komatsu — CLEAN AND CHECK TURBOCHARGER

SERVICE PROCEDURE MAINTENANCE CLEAN PPC CIRCUIT STRAINER 0. After the engine is stopped, the parts and oil are at high temperature, and may cause burns. Wait for the temperature to go down before starting the operation. When the rubber hose is removed, oil may spurt out, so turn it slowly to release the internal pressure, then remove it carefully. 1. When rubber hose (1) and flange (2) are removed, oil will spill out, so set a container (capacity: approx. 300 cc) in position to catch the oil. 2. Remove rubber hose (1) and flange (2). 3. Remove strainer (3) and wash it in clean diesel oil. 4. Install strainer (3) in strainer case (4) from the concave side, then install with flange (2).

REMARK Assemble with the protruding side (O-ring side) of the strainer at the front 5. Install rubber hose (1). CLEAN ENGINE BREATHER ELEMENT 0. The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the engine breather. When using compressed air, there is a hazard that dirt may be blown up and cause serious injury. Always use safety glasses, dust mask, or other protective equipment. 1. Wipe away dust around the breather. 2. Loosen the clamp and remove the hose. Remove breather (1). 3. Clean the breather body with light oil or cleaning oil. 4. Replace O-ring with new one.

Coat a new O-ring with engine oil, set it, then install breather (1). 5. Check the breather hose and pipe. If caked oil (sludge) adhere to insides, replace the hose and pipe with new parts. CHEK ALTERNATOR, STARTING MOTOR 0. The brush may be worn or may be no grease on the bearing, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours. CHECK ENGINE VALVE CLEARANCE, ADJUST 0. As special tool is required for removing and adjusting the parts, request your Komatsu distributor for service. CLEAN AND CHECK TURBOCHARGER 0.

If there is carbon or oil sludge stuck to the blower impeller, it will lower the performance of the turbochargeror cause it to break, so ask your Komatsu distributor to carry out the cleaning. 4-56 WARNING WARNING