TECHNICAL DATA LIMIT VALUES FOR SLOPES LIMIT VALUES FOR SLOPES Maximum slope angle for machine operation If operating the machine on a slope, its angle must not exceed 35° uphill, downhill or sideways. If you angle the machine at more than 35° during operation, the motor, transmission, hydraulic system or axles, will not be supplied with sufficient oil and can be damaged. A uphill 26° B downhill 35° C sideways 15° Tilt angle The tipping angle is a calculated value. This states the angle at which the machine at rest can stand on a slope without tipping over.
You must not work with the machine at these angles as the motor, transmission, hydraulic system or axles, will not be supplied with sufficient oil and can be damaged. The specified angle refers to the transport position. The angle changes if you raise or lower the work unit. A uphill with operating load 61,9° uphill without operating load 50,6° B downhill with operating load 35,2° downhill without operating load 56° C lateral with operating load 40,7° lateral without operating load 42° GK100372 5-5