Komatsu — SETTING ADDITION MODE

HANDLING LOAD METER ATTACHMENTS, OPTIONS 4. If the display is “REMAINS MODE“, press the (>) or ( monitor panel mode selector switch 2 to display "ADDITION MODE". 5. Press the ( ‘ ) of monitor panel selector switch 1 and display “MATERIAL SELECT". 6. Check the display for the selected material on load meter display (1). The present selection display is A. In the case of the addition mode, “TOTAL LOADED“ is dis- played on display (2). 7. If A is to remain selected, press the ( „ ) of monitor panel mode selector switch 1. A is then selected.

If A is to be changed to B to E, press the (>) or ( tor panel mode selector switch 2 to select the type of mate- rial, then press the ( „ ) of monitor panel mode selector switch 1. 8. This completes the setting of the addition mode. The character display returns to the normal service meter and time display. Once the setting has been made, even if the starting switch is turned OFF and operations are stopped, the setting is retained. When operations are started again, there is no need to carry out the setting again. All further loads will be added to the total load recorded before operations were stopped. 6-8