HANDLING LOAD METER ATTACHMENTS, OPTIONS 4. If the display is “ADDITION MODE“, press the (>) or ( monitor panel mode selector switch 2 to display "REMAIN MODE". 5. Press the ( ‘ ) of monitor panel selector switch 1 and display “INPUT TARGET“. 6. Input the target load. Before the target is input, “000.0 t“ is displayed on the target line and the cursor is at the 100 ton position. The following explanation explains the procedure when inputting 30 tons as the target. 7. “0“ is marked by the cursor at the 100 ton position, so leave it at “0“ and press the ( ‘ ) of monitor panel selector switch 1. “0“ is selected and the cursor moves to the 10 ton position. 8.
The “0“ at the 10 ton position must be changed to “3“, so press the (>) or ( to change to "3", then press the ( ‘ ) of monitor panel selec- tor switch 1. “3“ is selected and the cursor moves to the 1 ton position. 9. “0“ is already displayed at both the 1 ton and 0.1 ton posi- tions, so press the ( ‘ ) of monitor panel selector switch 1 twice. “0.0“ is selected and 30 tons is set as the target load. REMARK If 0 tons is input as the target load, it is not accepted. The buzzer gives a long sound and the mode changes to give the addition mode display. 10.Press the ( ‘ ) of monitor panel selector switch 1.
If the monitor accepts the input amount, the buzzer will give short sounds and “MATERIAL SELECT" is displayed. 6-10