Komatsu — CARRYING OUT CALIBRATION (ADJUSTING 0 POINT) WHEN LOADED

ATTACHMENTS, OPTIONS HANDLING LOAD METER CARRYING OUT CALIBRATION (ADJUSTING 0 POINT) WHEN LOADED 0. REMARK Normally, there is no need to carry out calibration when loaded. It is enough to carry out calibration when empty, so carry out calibration when loaded only if greater accuracy is required. 1. Check that the normal service meter and time are displayed on the character display. 2. Press the ( ‘ ) of monitor panel selector switch 1 and display “LOAD METER“. 3. Press the ( ‘ ) of monitor panel selector switch 1, then press the (>) or ( select "CALIBRATION". 4. Press the ( ‘ ) of monitor panel selector switch 1. “EMPTY BUCKET“ is displayed on the bottom line. 6-17