Komatsu — METHOD OF OPERATION

ATTACHMENTS, OPTIONS AIR CONDITIONER METHOD OF OPERATION 0. When carrying out the defrosting, if the temperature control switch is set so that all lamps are red, this will improve the per- formance for defrosting and demisting. Set the vent mode selector switch to the intermediate position to give the desired condition. With the FACE vents, it is possible to adjust the direction of the air flow and to turn it on or off. However, do not set to the FACE mode with the vents closed. WHEN NOT USING THE AIR CONDITIONER REGURARLY 0.

Run the air conditioner at cooling or dehumidification + heating for several minutes from time to time to prevent the loss of the oil film at various parts of the compressor. REMARK If the temperature inside the cab is low, the air conditioner may not work. In such cases, use the recircu- lated air to heat up the inside of the cab, then turn the air conditioner switch on to run the air conditioner.

6-33 Switchs Condition of use Fan switch Air conditioner switch Temperature control switch FRESH/ RECIRC air changeover switch Mode selector switch Cooling Rapid HI ON All blue RECIRC FACE Normal HI LO ON More than half are blue FRESH FACE Dehumidifying, heat- ing HI LO ON More than half are red FRESH FOOT Heating Rapid HI OFF All red RECIRC FOOT Normal HI LO OFF More than half are red FRESH FOOT Defroster HI ON More than half are red FRESH DEF Vetilation or pressur- izing HI LO OFF All blue FRESH FACE