ATTACHMENTS, OPTIONS MULTIFUNCTION LEVER KICKDOWN SWITCH 0. When the gearshift lever is in 2nd, if switch (14) on the head of the lift arm control lever is pressed, the transmission will shift down to 1st. Use this when you need to increase the drawbar pull in digging operations. If the transmission is in auto-shift, and the travel speed is below 12.5 km/h in any speed range when traveling in either forward or in reverse, the kick-down switch is actuated and it is possible to shift down to 1st. 1 This makes it easy to carry out load and carry operations. Even if the travel speed is more than 12.5 km/h, this switch can be used to shift the transmission down.
Each time the kick-down switch is pressed, the speed range will shift down one range at a time (F4 -> F3 -> F2). When the torque converter is in the lock-up condition (option), the lock-up is canceled. REMARK When canceling the kick-down, operate the directional lever. In manual shift, the kick-down can be canceled by operating the gearshift lever to any position other than 2nd. It is also possible to cancel the kick-down by turning the starting switch OFF. In auto-shift, if the travel speed becomes high after the kick-down, the gear will be shifted up by the auto-shift.
In auto-shift, when traveling at more than 25 km/h in 3rd or at more than 35 km/h in 4th, even if the kick- down switch is pressed, the transmission will not shift down. This is to prevent overrun of the engine. HOLD SWITCH 0. To fix the speed range when traveling in automatic transmis- sion, press switch (15) at the side of the lift arm control lever knob. The transmission will be fixed in the speed range dis- played on shift indicator (A) on the machine monitor and shift hold pilot lamp (B) will light up. When the switch is pressed again, the display goes out.
Use this function to select the desired speed range when trav- eling up or down hills or when carrying out operations such as grading. 2 REMARK When the torque converter is in the lock-up condition (option), the transmission cannot be fixed. When canceling the shift hold, operate the directional lever or gearshift lever or operate the transmission shift mode selector switch to MANUAL. It is also possible to cancel the hold shift by turning the starting switch OFF. 6-51