JOYSTICK STEERING SYSTEM ATTACHMENTS, OPTIONS GETTING IN OR OUT OF OPERATOR‘S CAB 0. Always spring the joystick console up before getting in or out of the operator‘s cab. If the console is sprung up, the safety switch is turned OFF and the joystick is automatically stopped from operating. The joystick console is a spring-up type to make it easier for the operator to get in and out of the operator‘s cab. If the joystick lever is moved accidentally when the engine is running, the machine may articulate unexpectedly. To prevent this danger, always spring the joystick console up when not using the joystick for operations and when getting in or out of the operator‘s cab. 1.
Set lock lever (1) to the FREE position. 2. Spring console (2) up. Turn it at least 90 degrees. The safety switch is turned OFF and the joystick cannot be operated. 3. When operating, lower joystick console (2) and push lock lever (1) down to the LOCK position. The safety switch is turned ON and the joystick can be selected. ADJUSTMENT OF JOYSTICK CONSOLE 0. Stop the machine on level ground in a safe place when carrying out the adjustment. Carry out the adjustment before starting operations or when changing operator shifts. Put your back against the backrest of the operator‘s seat and adjust the seat so that it is possible to depress the brake fully, then adjust the console.
Adjusting height 0. 1. Operate lever (1) in the cancel direction and loosen the lock. 2. Adjust the height of the console and set joystick lever (2) to the desired position. Amount of adjustment: 30 mm (1.2 in) 3. After setting, operate lever (1) to the LOCK position to lock it securely in position. Adjusting angle, fore/aft position 0. 1. Operate lever (3) in the cancel direction and loosen the lock. 2. Adjust the console and set joystick lever (2) to the desired position. Amount of fore/aft adjustment: 45 mm (1.8 in) 3. After setting, operate lever (3) to the LOCK position to lock it securely in position. 6-56 WARNING WARNING