EXPLANATION OF COMPONENTS OPERATION NOTICE When the starting switch is at the OFF position, if the service meter is displayed even although the top ( ‘ ) of monitor panel mode selector switch 1 is not being pressed, there is probably a failure in the machine, so please contact your Komatsu distributor for inspection. CLOCK 0. (only machines equipped with optional load meter) This display portion (2) shows the time. For details of the method of adjusting the time, see “METHOD OF SETTING TIME ON CLOCK ( 6-22 )“ in the ATTACHMENT AND OPTIONS section.
Even when the starting switch is at the OFF position, the time is displayed while the top ( ‘ ) position of monitor panel mode selector switch 1 is being pressed. ACTION CODE DISPLAY 0. If action code E03 is displayed, stop the machine immediately and check the failure code. For details, see “FAILURE CODE DISPLAY ( 3-12 )“. Inform your Komatsu distributor of the failure code and ask for repairs. If there is a failure on the machine, or it is necessary to change the method of operation, or if inspection or mainte- nance must be carried out, action code E00, E01, E02, or E03 is displayed on the character display in display por- tion (3).
If different failures occur at the same time, the action code for the more serious problem is displayed. The level of seriousness is as follows, starting with the most serious: E03, E02, E01, E00. In the case of action codes E00, E02, and E03, the alarm buzzer sounds intermittently and the central warning lamp lights up. If action codes E00, E01, E02, or E03 are displayed on the character display, stop operations, check the content of the display, and take the following action. E03: When this code is displayed, stop the machine immedi- ately, check the failure code, and contact your Komatsu dis- tributor for repairs.
REMARK The top line of the character display displays “E03“ and the bottom line displays “CHECK RIGHT NOW“ and “CALL“ in turn for 3 seconds each. The telephone number is displayed on the right of the “CALL“ display. If the telephone number has not been set, there is a blank. For details of the method of set- ting the telephone number, see “INPUT METHOD FOR TELEPHONE NUMBER ( 3-35 )“. 3-10 WARNING