Komatsu — CAUTION ITEMS

OPERATION EXPLANATION OF COMPONENTS At the same time, “E02 BRAKE OVERHEAT“ is displayed on the character display, so take the following action. 1. Release the accelerator pedal and move the gearshift lever down one range to reduce the travel speed. 2. Avoid using the brake. 1) Do not keep the brake depressed continuously; use the brake only intermittently. 2) When using the left brake pedal, turn the transmission cut-off switch ON to carry out operations. If use of the brake is reduced for a short time in the way recommended above, the axle oil temperature will go down and the caution lamp will go out. TORQUE CONVERTER OIL TEMPERATURE CAUTION LAMP 0.

This monitor (2) lights up to warn the operator that the torque converter oil temperature has risen. During checks before starting (when the starting switch is turned to the ON position but the engine is not started), this monitor does not light up. During operation (engine running) If the torque converter oil temperature rises, the torque con- verter oil temperature caution lamp only will light up. If the oil temperature rises further, the central warning lamp will light up and the alarm buzzer will sound intermittently.

At the same time as the central warning lamp lights up, “E02 TC OVERHEAT“ is displayed on the character display, so stop the machine and run the engine under no load at a mid-range speed until the lamp goes out. ENGINE COOLING WATER TEMPERATURE CAUTION LAMP 0. This monitor (3) lights up to warn the operator that the engine cooling water temperature has risen. During checks before starting (when the starting switch is turned to the ON position but the engine is not started), this monitor does not light up. During operation (engine running) If the engine cooling water temperature rises, the engine cool- ing water temperature caution lamp only will light up.

If the water temperature rises further, the central warning lamp will light up and the alarm buzzer will sound intermittently. At the same time as the central warning lamp lights up, “E02 ENGINE OVERHEAT“ is displayed on the character display, so stop the machine and run the engine under no load at a mid- range speed until the lamp goes out. 3-19