eng — PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING 3 - 103 BEFORE STORAGE more than one month), store as follows. ed, house the machine in a dry building. Never leave it outdoors. When keeping in long-term storage ( After every part is washed and dri ed, house the machine in a dry building. Never lea In case it is indispensable to leave it outdoors, park the machine on the flat ground a nd cover it with canvas etc. Completely fill the fuel tank. This prevents moisture from collecting. re storage. ydraulic cylinder piston rod with grease.

Lubricate and change the oil befo Coat the exposed portion of the h Disconnect the negative terminals of the battery and cover it or remove it from the mac hine and store it separately. Lock the dump lever at the HOLD position with the safety lock, and apply the parkin g brake. Set the tire inflation pressure for e ach tire to within the range of the specified inflation pressure for the type of tire.

Open the drain valve of the air tan k, release the air, then tighten the drain valve aga Push the retarder control lever for Place the gear shift lever at the N To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permanent typ e antifreeze (density between 30% and 68%). If it is necessary to perform the rust-prev ention operation while the machine is indoors, open the d oors and window s to improve ventilation and prevent gas poisoning. Operate the engine and move the ma chine for a short distance once a month so that a n ew film of oil wi ll be coated over movable parts and component surfaces. At the same time, also charge the batter y. .

Before operating the work equipmen t, wipe off all the grease from hydraulic piston rods AFTER STORAGE NOTICE If the machine has been stored without carrying out the monthly rust-prevention operation, con sult your Komats u distributor before using it. When using the machine after long-t erm storage, do as follows before using it. aulic cylinder rods. n points. Wipe off the grease from the hydr Add oil and grease at all lubricatio When the machine is stored for a lo ng period, moisture in the air will mix with the oil. C heck the oil befo re and after starting the engine. If there is wat er in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE 1.

Check all the oil and water levels 2. When traveling after long-term st or 1 km to run the machine in, th 1. Check all the oil and water levels 2. When traveling after long-term st orage, travel forward at a speed of 10 to 15 km/h (6. 2 to 9.3 MPH) fo r 5 minutes en change to normal travel.