. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM REAR BRAKE WARNING the plug BLEED AIR FROM FRONT BRAKE WARNING hose 4 - 28 Stop the machine on level ground and put blocks u nder the wheels b To make it easier t o bleed the air, warm the oil up to a tempera of at least 40°C (1 04°F) before bleeding the ai r. 1. Pull the retarde the air from th retarder brake 2. Repeat this pro bleed plug (1). (1) securely. 1. Pull the retarde r brake lever, loosen air ble ed plug (1) to bl e circuit, then tighten plug (1) and release lever. 2.
Repeat this pro cedure until no more bubble s come out from After completely bleeding the air, tighten Stop the machine on level ground and put blocks un der the wheels be bleeding the air. 1. Start the engi ne and raise the pressur e to the maxim position in the green range on the air pres 2. Fill oil reservoi 3. Remove the c ap of bleeder screw (2), i er: 8 mm (0.315in)), then 3/4 turns and depress the nsert a vinyl h (inside diamet screw approx. After tightenin Repeat this pro vinyl hose. loosen the blee brake pedal slo g the bleeder screw, releas e the brake pe cedure until no more bubble s come out from Do not keep th it each time slo After bleeding t the cap.
e brake pedal depressed co ntinuously. Depr wly to bleed the air. he air, tighten bleeder screw (2) securely an 4. After completio n of the air bleeding proced ure, fill the oil r eservoir to the specified level Repeat the same p rocedure on the left and rig When bleeding the air from the front brakes and rear brakes at t he same time, bleed the air fro m the rear brakes first