. MAINTENANCE SERVICE PROCEDURE ADJUSTMENT If the fan belt makes any abnormal noise, adjust in the same way. REMARK when inspecting the play, check first that the engine fan is not rotating. If the result of the measurement shows that it is greater than the standard value, please contact your Komatsu distributor for disassembly and inspection. 4 - 33 1. Install adjustme nt bolt (1) and locknut (2) to yo 2. Tighten adjustm ent bolt (1) until the clearance h ends of the oblong hole of y oke (3) and pin lley (5), then tighten a further (2) to hold in position. r, then check the clearance be 3. Run for one hou tween the end le of yoke (3) and pin (6) of ten sion pulley (5).
earance, repeat Step 2 to adju CHECK PLAY OF OUTPUT COUPLING OF OUTPUT SHAFT If any abnormal nois e occurs around the output sh aft or front drive shaft, the rubber in side the output shaft may be damaged, so check the play of the coupling as foll Play in circumferent Using a bar, mo circumference and c heck the play in the circumfere ntial direction at the outside diamete Standard: Max. 15 If the play range is e xceeded, the engine fan will st art to rotate, so