eng — SELECTION AND INSPECTION OF TIRES

. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING Tire size Inflation pressure 27.00R49 !! (standard) 0.69 MPa (7.00 kgf/cm 2 , 99.4 PSI) 27.00-49-48PR (if equipped) 0.55 MPa (5.60 kgf/cm 2 , 79.52 PSI) NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kgf/cm 2 , 4.3 PSI) of the value in the table above. PRECAUTIONS WHEN REPLACING TIRE If the hub nuts have been tightened again after replacing the tire, travel for 5 to 6 km, then tighten again to settle all the contacting parts.

In particular, there are more contacting parts on the rear wheels than on the front wheels, so it will take time for the parts to settle. For this reason, repeat the tightening process for the first 50 hours after installation. However, on the rear wheels, there are hub nuts at 3 places on the inside, but these are for temporary assembly, so there is no need to tighten the inside hub nuts after the outside hub nuts are tightened. 4 - 35 When inflati ng a tire, check th at any person will not enter the working area and use an air chuck whi ch has a clip an d which can be fix ed to the air valve.

While inflati ng the tire, check t he inflation pre ssure occasional ly so that it will not ris e too high. If the rim is n ot fitted normally , it may be brok en and scattered while the tire is inflate d. Accordingly, p lace a guard a round the tire an d do not work in fron t of the rim but w ork on the trea d side of the tire. f the rim Abnormal d rop of inflation p ressure and a bnormal fitting o rim indicate a tr ouble in the tire or rim. In this case, be sure to ask a tire repair shop for repair. bserve the specified inflation pressure. st the inflation pressure of the tires just after high-speed vy-load work.

Be sure to o bserve the specif ied inflation pr Do not adju st the inflation pr travel or hea vy-load work. Check Measure the i nflation pressur e with a tire pressure gauge , while the tires are cool, before s Inflation of tires ation pressure properly. Adjust the infl ation pressure When inflatin g a tire, use an air chuck whi ch can be fixed to the air valve of the tire as sho wn in the figure. Do not work in front of the rim but w ork on the tre ad side of the ti The proper in flation pressure is shown bel